collotype n : a photomechanical printing process that uses a glass plate with a gelatin surface that carries the image to be reproduced; can be used with one or more colors [syn: collotype printing, photogelatin process]

Collotype is a dichromate-based photographic process developed for large volume mechanical printing before the existence of cheaper offset lithography. It can produce results difficult to distinguish from metal-based photographic prints because of its microscopically fine reticulations which comprise the image. Many old postcards are collotypes. While no longer a commercial process, its possibilities for fine art photography were first employed by Todd Walker in the 1970s.

The collotype plate is made by coating a plate of glass or metal with a substrate composed of gelatin or other colloid and hardening it. Then it is coated with a thick coat of dichromated gelatine and dried carefully at a controlled temperature (a little over 50 degrees Celsius) so it 'reticulates' or breaks up into a finely grained pattern when washed later in approximately 16 °C water. The plate is then exposed in contact with the negative using an ultraviolet (UV) light source which changes the ability of the exposed gelatine to absorb water later. The plate is developed by carefully washing out the dichromate salt and dried without heat. The plate is left in a cool dry place to cure for 24 hours before using it to print.

To produce prints, the plate is dampened with a glycerine/water mixture which is slightly acidic , then blotted before inking with collotype ink using a leather or velvet roller. A hard finished paper such as Bristol, is then put on top of the plate and covered with a tympan before being printed typically using a hand proof press. Collotypes are printed using less pressure than is used in printing intaglio, or stone lithography. While it is possible to print by hand using a roller or brayer, an acceptable consistency of pressure and even distribution of ink is most effectively achieved using a press.